Recent content by MiltyOO

  1. M

    Zd25 safety switches

    What is it in the electrical circuit that shuts the engine down after 3 seconds when you do not have the park brake handle pushed all the way forward? I know you have to pull it back to release the brake and crank the engine while holding it there then you have to push it forward to keep the...
  2. M

    WANTED: Fuel pump

    Thanks for the help. I got this one sold and he wants it factory. This pump is about 1/2 the length of a reg. electric fuel pump and not as big around and bolts in two places on the engine block. everything is so tight on these it is pathetic.
  3. M

    Lock out switches

    How do you install a relay or "step-up" transformer in the line to the starter solenoid on a ZD25 zero turn diesel mower? The voltage will not get up to enough to kick the solenoid starter in because of the micro switches. Probably some are worn and building up resistance. Can't figure out which...
  4. M

    WANTED: Fuel pump

    WANTED: 1 electric diesel fuel pump for a ZD28 zero turn mower. Kubota part number: Rc 601-51350 or (2) (new number change from 0). Call Milton 843-276-7505
  5. M

    Zero turn mowers

    Is this the correct place to ask for information on Kubota zero turn mowers?
  6. M

    hard steering

    ZD28F left hand steering will hardly move cannot turn when going in reverse at all.
  7. M

    Lock out switches

    I HAVE 3EACH. 2 ZD28 AND ONE ZD25 AND THEY ALL HAVE THE SAME PROBLEM. I GUESS THE SAFETY SWITCHES HAVE CORRODED CONTACTS AND ARE NOT ALLOWING CURRENT TO GET TO THE SOLENOID TO CRANK THE ENGINE AND SOMETIMES WHEN IT DOES CRANK THEY WILL SHUT OFF AFTER THE 3 SECOND BUILT IN SAFETY QUESTION, HOW DO...
  8. M

    For sale zd 28 72" cut

    Kubota zd28f 72 inch diesel zero turn commercial mower only $7700.00 • model: 2005 serial number 60160 only 1550 hours • 24x 12.00x 12 turf tires on rear, 15*6.00x6 front simi groove • zd 72” fabricated deck s/n 16438 (not a stamped steel deck) and welded attachments has optional metal...
  9. M

    safety switches

    I have a ZD28F. I have to jump start it to run. I checked with an amp meter and there is no 12v coming to the solenoid when the starter is activated. It also will shut down when I start moving different distances,, like another switch is disconnecting. Any help? Milty