marrmanu's latest activity
-
marrmanu replied to the thread Off setting 48" Rotary Mower.Thanks all for the input. I have looked at a 3pt offset flail mower, however I just don't have that much to do to justify the expense... -
Has anybody offset their 3pt rotary mower, or any reasons why this might cause issues? Thanks Mike
-
I have a TerraKing TKV20 for my BX2380, and the tractor needs some front counterweights. I called my Kubota sales guy, and the bracket...
-
It works perfect for my need. However, I'll have to revisit my prototype chainsaw mount, after I get my roof project completed.
-
I will never forget the feeling of being sucker punched in the guts when I heard the horrible news that morning on the truck radio. Just...
-
marrmanu replied to the thread Tractor turns over but won’t start.I kinda had the same issue with my 2620. In my case I but a new battery in, started ran then after sitting would not start, I jumped...
-
It’s all about your eyes. They tell your hands what to do. If you wear bifocals or use cheater glasses to see up close you will have to...
-
Building a land plane to maintain my gravel drive way. Using steel I have on hand, I am having a couple plates made where I used to...
-
I am working on a project adding a 12'x40' lean to addition to my shop/garage for firewood storage. In retrospect I should have done...
-
marrmanu replied to the thread BX23 with bacteria clogged fuel tank.I guess the bx 2370 and the bx 23s must be different, because all I had to do was tip the seat forward and start cutting, no removing...
-
marrmanu replied to the thread BX23 with bacteria clogged fuel tank.Had same problem on my bx2370. There are a couple of videos on youtube that do the access port in the tank. I did not want to pull the...
-
marrmanu reacted to Runs With Scissors's post in the thread BX23 with bacteria clogged fuel tank with
Like.
I think @GreensvilleJay has it right. However, That access port looks like a cool idea. Some of the aircraft I used to work on... -
Or just get a few guppies, they will eat all the bugs
-
Depends on how big a valve you need. For years I have used plastic 1/4"npt valves drilled & tapped directly into the side/bottom edge...
-
The coupling were out on the little B2620 and instead of splitting the tractor i turned the shaft down to the same size as the base of...