Recent content by mark123

I was looking at putting lights on my rops that face backwards, that way I can see behind me. I was wondering if anyone has done this before and if so how you wired it up. I am thinking of either tapping into my switch for the front lights, or just adding a new toggle switch just for the rear...

I was thinking of doing this exact same thing with my tractor. Another option you may want to consider is getting the teeth from a backhoe and if you have a powerful enough drill, just drill holes in the bucket and bolt the teeth on like a backhoe, that way when to don't need them you can take...

I cut that piece and it quite making noise. Thanks for all the help.

thanks, i cut it and that helped a lot. I can still kind of hear the noise, but it is faint, before I could hear it over the motor. once again thanks

I was wondering how to post pics? thanks

C:\Documents and Settings\Owner\My Documents\My Pictures\trac

I an looking at changing the trans fluid in my 7800. I was wondering how many filters it has and if I am right about it having between 3 and 4 gallons of fluid or if I miss read something? thanks

not to offened anyone, bitwould a little plastic piece be causing this? you are the third person that has said that it could be the trans. thanks for the imput.

for a new topic, dont know if it has to do with the front end or not, but waht could make the tractor sound like a european siren? It does it in 4H and 2H. thanks

I was wondering if you may know what would cause a 7800 to make a sound like a european siren at full petal. This happens in 4H and 2H. thanks

thanks, it was pretty easy to do. those inside bolts were a killer though. thanks again for the help.

how tight should the bolts be tightened to? The four and the lug nuts? Thanks

my father accidently dropped a small screw drive into the axle trying to check the level, no I am trying to pull the right tire off and get to it. I have the tire off and the castle nut holding the rod together. I was wondering if I could undo those four bolts holding the spindle and everything...

front right, because I have to and will leave it at that.

do you have any pics for pulling the front axle on a 7800? thanks