Recent content by jdl25

  1. J

    My turn to cry

    I'll tackle it after Christmas, no pressing tractor jobs on the horizon! I appreciate the words of encouragement and I'll update the thread as I go.
  2. J

    My turn to cry

    I am not scared.
  3. J

    My turn to cry

    I can have the fel and sub frame off in an hour I think. I don't have a back hoe.
  4. J

    My turn to cry

    2700....edit to add the clutch felt great. I'm fairly certain something broke in the clutch assembly.
  5. J

    My turn to cry

    So I took a side job of Bush hogging about 5 acres. I had done a nice job in a few hours when the clutch in my Kubota L2650 made a noise (like I sheared a bolt) except the clutch stayed engaged and it was obviously burning. Dagummit something inside broke. So tomorrow I get to load a disabled...
  6. J

    Hydraulic Fluid change...question

    I located a large slotted screw that had a snap ring under the head. The screw was in the hydraulic pump where the loader hoses originate. I turned this screw to the opposite extreme and the 3PH started working. I shut the tractor down and then put the screw back where it was. I believe when...
  7. J

    Hydraulic Fluid change...question

    L2650, just replaced the dry dual stage clutch. So far so good (the tractor moves again). I drained all the hydraulic fluid and replaced same during the clutch replacement. I don't understand something though... why do I have two Oil Fill locations and only one sight glass? I have an oil fill...
  8. J

    Loader question

    Can't you just document the condition of the tractor before and after and bill their cc?
  9. J

    15 degrees F no hydraulics

    Sounds like good logic I believe I'll start here.
  10. J

    L2650 Won't move.....

    If it is an EVERCLUTCH what fluid should be in it?
  11. J

    15 degrees F no hydraulics

    I wish they were. I got power steering, all my front end loader function, lift is correct. Just don't have any power at the wheels. Almost like the clutch is not disengaging. But low range first gear seems to work...
  12. J

    L2650 Won't move.....

    Tractor is fairly new to me, first winter with it and temps have been 12-30 degrees F for the last 10 days..... Kubota L2650, Shuttle Shift, 4x4. 2500 Hours. factory front end loader, has prompt response and full range lift and curl tiller on the 3 point hitch, prompt response, goes up and...
  13. J

    15 degrees F no hydraulics

    I just came here to post a similar thread. Following...
  14. J

    Oil leak...what went here?

    Thank you eserv... I emailed my local dealer. I hope they have one in stock. I will look in the area where I was working first but suspect it's long gone.
  15. J

    Oil leak...what went here?

    I believe so... Any help with a part number? I can't seem to find one.