Recent content by Hunter1157

Getting ready do do my first coolant change on my MX6000 with a cab. What is the proceedure on doing it with the cab heater involved? I want to make sure I get all the old stuff out. Also thinking about using either Zerex GO5 or Peak Final Charge Pro Series antifreeze for the refill. Any...

I ordered this one when I got my MX6000 and so far it is holding up well. I ordered it from Amazon. I am interested how you like yours. https://durafitseatcovers.com/ku20/?setCurrencyId=1&sku=KU20-LOSTC&gad_source=1

What year is your tractor? I have a 2020 and am wondering if this is something I need to check into before my extended warranty runs out in April.

2020 MX6000 HSTC and a 2020 RTV X1140

jaxs, I am interested in this statement you made earlier. My MX has a flimsy screen in front of the AC condenser/coil that doesn't even cover 2/3's of it. I feel it is more of a hinderance than a help. I flush all the coils and radiator after each use. So I would assume removing that screen...

There are several bolts that have plastic caps on them that remove it. just pull the plastic caps and remove the bolts. The headliner stays in place. My wife and i got on ladders on both sides and lifted it off. In my case I did not replace the seal because it looked like new.

On my two pictures I used the 3m adhesive to keep the batt insulation in place where I laid it. The only thing that was under the roof when I removed it was what looked like a piece of carpet pad right over the drivers seat. Basically nothing for factory insulation. The small silver pieces are...

I just used some batt insulation we had left over from a project and a little 3m spray adhesive. The roof will hold it in place.

The three things I did to my 6000 that made mine very comfortable in this Texas heat is full window tint, I pulled the roof and insulated under it and I put heat/sound insulation on all the metal under the seat down to the floor.

Glad it was an easy fix. Now get out there and put that thing to work!

What mcmxi said. I have had my steering wheel tilted both up and down and the loader control lever has never been close to it. I also have the Kubota factory 3rd function control.

I run my MX6000 at 2000 to 2200 rpm while using my LP 2072 rotary cutter. It cuts just as well as running 2700 rpm and I am not listening to the engine scream. Couldn't tell you if it saves any fuel or not. Mine seems to regen about every 40 hours and has since new.

I will be following this. I would like to do the same with my MX6000 with cab. Right now I have a canvas tool bag behind the seat and a Crown Royal bag with bushings and pins in it and a pair of gloves in the little plastic box next to the seat.

Just use a crescent wrench on mine and seems to work fine so far.

I just treated my new 20' car hauler with old oil change oil, came out great and cost nothing. This is what I have been using for years. Works great. I apply it with a foam roller.