Recent content by GeekBoy100

Interested in the WSM for LX2610/3310

My best guess is they are pipe plugs and are used to either relieve pressure to bleed air from the system. My real question is other than "tight" is there anything else in the valving or flow control that these might control?

The set screws

The two set screws is what I adjusted. I didn't touch the mounting bolts.

Small leak at the lines on the loader for the third function. Nothing related to the third function valve. They also performed the lx3310 campaign.

I have an LX3310 and had my tractor to the dealer for a repair. When I got the tractor back the bottom on the third function valve was dripping when the tractor was running. I noticed two hex set screws visible on the bottom (6mm hex) and I tried tightening them a little and that stopped the...

Thank you everyone. This fourm is awesome. The spacers were zip tied to one of the arms. I didn't see them mentioned in the manual. However, I now have them installed and everything is SO much better now.

I noticed on Messicks there is a spacer that can be put on the shaft for the lower link. I'm pretty sure they came zip tied to the 3 point assembly. I bet these spacers keep the lower links out far enough to not his the stops. Thoughts?

I posted before and got some super helpful tips. However, I have run into a weird one. I installed 3" wheel spacers on my rear wheels today so I would have lots of clearance for tire chains. I reinstalled the snow blower and it will not lower to the ground. I would say it is happy about 1.5"...

Thank you for the details about the top and lower links. I will try on the weekend and learn the difference it makes. Lots to learn!

Thanks, I looked at the lower link and saw the extra hole that should put the implements closer to the ground. I also reviewed the manual. My top link only had two holes, but get the idea.

My three point hitch seems really high. The blower barely touches the ground but the woods chipper will not sit on the ground by close to 8" and I need to put blocks of wood under the chipper. Would a quick hitch help? I'm new to tractors. Thanks