Recent content by fundyrider

As I suspected, the sway control arms should have been installed when the tractor was assembled. . Be an expensive job to pay to have it corrected and I don't relish the thought of tackling it . I will go with my original plan and make my own.

Thanks for the suggestions. The 4 bolts are only part of what's holding it Put my MacGyver skills in gear. I took a piece of flat bar and made a "U" and drilled holes for the pin to insert then slid it over the shaft. (Part 40 above) Does the job, sway bar hooks up the same as original...

Thanks for the replies, I will take a photo into the Kubota dealer and see if they have a solution. I'm thinking with this frame setup, the sway arm ends should have been installed at the factory then would just have to attach the rest of the sway arm and insert a cotter key. Likely will have...

Just bought 2015 B2601 with hoe. Previous owner never had the hoe off so never installed the 3 point hitch. I am stumped how to attach the sway control bars to the lower pin. From what I can tell, the pin has to be pulled out but the hoe frame prevents it from doing so. Help appreciated.