Recent content by Frankb

I love mine!

That's the one I wanted to remove but couldn't get up into that space. Will need to try again. Thanks Frank B

Where exactly is this spring you removed, and on what side of the tractor is it located? On the right side where treadle is located it has two springs under the floor board. On the left side of tractor where brake peddle is located there is one spring under the floor board that controls a safety...

As I stated in other post above, my cutting edge came from my local Kubota dealer. Just under $200, and included the bolts and nuts for the install. Fit perfect, and I use it all the time and it still shows no wear at all. Great protection for the bucket edge. The bucket came with the holes...

Don't forget a few clean rags to keep on hand to wipe the zerks before greasing. A small flashlight is also good to have on hand. I have two boxes on my B2601 to keep a scraper knife, screw driver, rag, couple extra pins for your attachments in use, hat, gloves, one each of adjustable wrenches,

Parts are ordered and now I wait.

Look back at post #17. It shows where I used flat stock and switched over to the narrow angle iron stock. Much more stable and no wiggling of mirrors. angle stock came from Lowes. I bought a 3' length and cut what I needed, cleaned and sanded before painting. A 3' length cut in half will get...

Ordered all the parts this morning first thing. Now we wait......and wait.....and wait....... WAITING OVER HERE!

I looked up all the parts needed and total is just below the hundred mark. I will contact dealer tomorrow. Thanks for the information. Will post once I install!

That was the video I needed. Thanks for the video post!

I know this has been mentioned before, but I need to know about the B2601 tractor with a LA435. I built a level indicator for my L series tractor I used to have and it worked great, but I want to add one to the new B2601 now. I don't really need it so much any more, but it would be nice for a...

Looks good bbxlr8. If you ever have to raise the mirrors, I think you have enough of that tower that you can add a length of 1" angle iron to the outside of the tower, and clamp it where your clamp is now and once again a couple inches just below that clamp. That will give you height if needed...

I did not have to drill any holes in tractor at all. I used the existing holes in the towers with large heavy washers so I can tighten them without deforming the washers in the large holes. Nothing has come loose yet and I have been doing a lot of digging and grapple work and shaking the...

PICTURES!

I can't imagine being without these mirrors now. I had to go on our road and even though it is a private road, the neighbors run up and down rather fast and I can't hear them coming over the tractor noise, and I feel much safer knowing who is coming up behind me when I am on that road! Good luck...