Recent content by England14

The spacers just keep it from being sloppy. If I were after max strength I would weld in a tube the exact length. Remember we talking about a BX. Not a lot of lift capacity anyway. Only 3/4 inch pins. The fork rack goes on and off fairly easy, but the bucket is still a little hard to align...

Picky picky picky [/URL][/IMG] [/URL][/IMG] [/URL][/IMG]

I finally found a Quick Attach for a BX-25 on eBay and got it. The geometry is the same but it did require some mods to make it work. Apparently the BX-25 has wider arms than the BX-23 so there was some spacers needed to mount it. And then there is the question of the pins which Kubota wants...

Check my pressure today and it is set at 1900. Think I would benefit from increasing it to 2000?

I am finding my self use the clamp-on forks more than expected. By the time I extend the load out past the bucket and with the limited lift capacity of the BX23 I am needing a little more lift. Was thinking about...

I just got a set off eBay for $99 plus shipping! http://www.ebay.com/itm/191558775694?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

Just realized you are not that far away from me! What you take for it as-is???:rolleyes:

Fix it and if you are not happy with the results then sell it. ;)

I paid $11500 for my BX23 without a MMM and thought I got a good deal. Looks like you are getting a better deal! :eek:

$11,500 It's not new, but I think it will do what I need.

I was ready to pull the trigger on a new BX25D1 when I found a BX23 for $8500 less so I bought the 23. Now I am wondering if I made the right choice? The 23 has just a little over 700 hours and everything seems to work fine. I asked the dealer about the differences and he said the big...

Are you not using a quick attach to switch from bucket to forks? If not how much of a problem is it to switch out from one to the other. (maybe time for a video) The one on eBay locks the forks in at top and bottom except for a space in the middle where you have to slide the forks to remove...

Looks good but the forks look like they are fixed. I found a set on eBay I have been thinking about that have moveable forks and they are made for the BX tractors. I e-mailed the guy and he says they weigh 125lbs for the frame and forks...

Kubota web sight calls it a "Quick Hitch" but the dealer don't know for sure if it will work on the BX24. I think they are trying to talk me into a new tractor. I was hoping someone had tried it already. I guess I need to do some measuring. Eyeballing looks like it will work.

BX25 Quick Hitch/Attach on a BX23? Just bought a used BX23 and I am trying to figure out what I want for forks. Was thinking about the Kubota Quick Hitch for the BX25 but not sure if it would work on my BX23 with a LA210-1 FEL. Anybody try it? I am tempted to order a cheap set of clamp-on...