Recent content by Duffsfarm

Hi Naturalp, Attached are quick measurements I took from my B7000D, let me know if you need any more info.

Hi Brandon, I had the same issue with my B7200D but I just fitted 33 x 12.50 - 15 lug tires to the 15 inch rims. They maintain the height / circumference ratio to match the 6 - 12 R1 tires on the front.

North Idaho Wolfman, good point on the shield, I was thinking about fitting one. Yes the hitch makes changing attachments very quick and no need to leave the seat.

It is a typical European style hitch, unfortunately Kubota don't make one, hence the home build. The hook is from a hitch off a Ferguson 20, I just fabricated the mounts, latching mechanism and lifters. The hitch always comes up to its final latching height which is fixed. It is all set up so...

I made an automatic trailer hitch for my B7200. The trailer hook is lowered by the 3 point arms. You then reverse back to the trailer until the hook is under the towing eye and then lift the hook. The latching mechanism automatically locks the raised hitch in place. I have posted a video on You...

Just thought I would share the quick hitch arrangement I made for my Kubota B7200. It is a simple system with hooks on the top of the loader part and hydraulically operated locking pins on the bottom. The pins are operated by the crown / dump valve on the loader control. I installed two manually...

I fitted a power steering when I was upgrading the loader. For the loader upgrade I installed a separate hydraulic pump driven off the crank shaft pulley on the front of the engine. When I was ordering the pump I went for a tandem pump set up and got a smaller separate pump fitted to operate the...

Hi Lencho, I am away for a few days, when I get back I will post some pictures and details

Hi Hooverscon, yes I had to get the front wheels made because I couldn't find any pre made ones to fit. I was able to find the agri tyres to fit the 15 inch rims on the back to give me the width and maintain rolling circumference

The standard tyre sizes for the B7200 are on this sheet

Hi Hooverscon, I got the wheels made as a 12" version of the 10" turf wheels that were on the tractor. I did have to reduce the turning angle (adjusted the stops out on the axle) to prevent the tyres clashing with the tractor frame because of the width. It increased the turning circle a bit but...

I finally got round to getting new wheels made for the front of the B7200D. The standard 12" rims only accept 6-12 agri tyres. I wanted to fit wider tyres on the front which would help with loader work. I got new rims manufactured that fit 23x8.50-12 tyres. They work well and match the...

Hi Bobby T, sorry I missed your question, are you still looking for the photos of the frame?

Hi, if you are still looking for info, you can download the B6200 / 7200 manual which has the tire sizes in it from here http://www.kubotabooks.com/AutoIndex/index.php?dir=Tractor%20Owners%20Manuals/ With 9.5-16 on the rear, use 6-12 on the front

Thanks all for the comments. I was thinking of getting some Kubota badges to put on it. I had the same problem as ShaunRH, any trailers that I looked buying around the size I wanted all had low load capacities and looked light and flimsy. I built the trailer as a heavy duty unit with closely...