Recent content by domigold

I think this will work. Thanks

Don't you need a PTO shaft with a hole to use that extension? I don't think the PTO on my L2501 has one.

What do you use for your PTO extension? Thanks

Where would one find a mount plate for some QC rear remotes (2 set, 4 holes)? Thanks.

Thank you. Thank you for the clear diagram. The ports on the block are NTPF but the hoses are JIC and they just use adapters between them.

Interesting. My buddy thought that his L3301 port was NPT and found out that it's actual JIC. Did you actually open and inspect it?

I got it. JIC 8 is the dash size. Its tube size is 1/2.

Thanks, JIC 8 is JIC 1/2", right?

Does anyone know off hand what the thread type/size of the Power Beyond and tank ports on the front hydraulic block? Thanks.

In my loaded R4, I have it a round 20psi. I'm thinking about lowering it a bit more to 12-15psi to help with traction. Thought I double check what's everyone else is doing. Thanks everyone.

The doc said 30psi. I found it to be too rough. Thinking about letting some air out. Perhaps to 15psi. What do you run yours at? Thanks.

Thanks everyone for your input. I will mainly use this to level about an acre to seed a lawn. Got a good deal on a used LMC 6' BB so that's what I'll be getting. I probably won't keep it after this job since I got no other use for it.

What's your take? Thanks

Thank you all for taking the time to answer my question. My loader is LA525 and the 3rd function is dealer installed (I think it is Land Pride kit). The PB out from the 3rd function runs to the PB on the front hydraulic block to power the 3 point hitch. The LA525 loader does have a return to...

I bought a L2501 with 3rd function setup (true 3rd function, not diverter valve). I noticed that the 3rd function valve only has 4 ports: 2 going to the front for the 3rd function, one goes to the loader PB port, and the other goes to the PB port on the front hydraulic block. I think the line...