Recent content by Dirtboi55

I guess I need to learn to use the quote button...Sorry. But I am having an engine performance issue with it. I am currently trying to figure out. and I posted some pictures in an album on this site as well. Thanks for having me as a new member, I look forward to chatting with you all as the...

I bought the unit that way. It broke the piston in half at the wrist pin and threw the rod through the block. The guy I bought it from didn't know either, he bought it from an auction that way as well. It only shows 106 hours on the hour meter. I haven't figured out why it wasn't sent in as a...

I would say all total I put close to another $1000.00 dollars against the $4200.00 new motor. Most of the parts I just had to remove from the original motor and install onto the new motor. The only thing that I was able to use from the new motor was the engine block and all of it's internals...

Does anyone own, or has anyone used a Kubota Diagnostic laptop/Tool. I can pick this one up on eBay for 1300 bucks. But before I buy it I was hoping someone could tell me whether or not it will work on the Kubota L3301 HST (D1803-CR-EF06) ECMs KUBOTA / TAKEUCHI DIAGNOSTIC SOLUTION WITH...

So I'm thinking after reading some of the other posts on here that the error code P0101 is an old code that is still in the system, and it has nothing to do with my issue. because someone on here said that engine codes are cleared by turning the key off and on, but the trouble code still remains...

Hi lugbolt, I was thinking something similar, so I pulled all the breather pipe all the way back to the throttle body, and looked down into the intake manifold with a flash light. Then I ran it completely without an air cleaner and it failed as soon as it warmed up, ( see reply I left for Dave)...

Thanks for the quick reply Dave. This tractor does not have a turbo charger. So as an update, I had a brand new MAF sensor on hand. I replaced the MAF sensor just now, buttoned it up and ran it again. It did exactly the same thing. The very moment that the engine reached normal operating...

I don't know anything about your v-1505-e to D1503, But I just swapped my Blown D1803 L3301 HST motor with an E-Bay Bought D1803 motor out of who knows what. I called every Kubota dealer from Arizona to Michigan and no one could tell me what a (Kubota P/N 1J497-10000) engine goes to. This...

Hello All, I have a 2017 L3301 HST and I am getting P0101 code. when this unit warms up for 10 minutes or so, it begins to put out a lot of smoke from the exhaust and run terrible. It seems like the fuel/air mixture is running Very Rich after warm up. The manual says that P0101 is Intake...