Recent content by dan lee

Thanks Jim, yes cylinders looked good, I cracked the lines below the injectors and had fuel, how can I check if injectors are clogged? thanks, also I do have some white smoke while cranking

I acquired this non running L200 about 6 months ago and after spending 1500 on parts, it is still sitting in corner of my barn about to become a yard ornament. It has 633 hours on it and I don't have the tools to go any farther. It cranks but won't pop, I sent the head in to a machine shop and...

I did pull the engine but the only thing I did was took head into machine shop and had new valves,guides, seals and springs put on, reinstalled the head with a new head gasket and still nothing, glow plugs are working well too, also adjusted valves to spec

the glow plug indicator does light bright red, I noticed there is iike a coiled resistor on top of crankcase below battery box

any ideas appreciated, I put 2 new glow plugs in and still can't start, my question is, when I hold volt tester lead on hot wire to plug, (not hooked up) and turn glow plug switch, I have 12.4 volts, when I hook wire up to glow plugs and turn on switch I have 1.7 volts at both glow plugs. Does...

thanks, I will recheck glow plugs, glow plug indicator glows on dash, but will check individual plugs

I have an L200 that cranks but won't start, does anyone know if it has a fuel cut off solenoid, it is getting fuel, I tried new fuel and filter, and bled lines. Previous owner said it had gradually been getting harder to start then finally not at all. it is a 2 cylinder 1972 diesel. any...

again, good photography work

Thanks Rodger, those are some pretty nice pictures

thank you Rodger, I do know of a tractor group in my area and will get in touch with one of the members

can anyone help me with the tightening sequence and foot pounds of torque on my 6 head bolts? thanks, i only have an operators manual with the tractor, L200 2 cylinder 1.1 liter

does anyone know where I can have a Z1100 Diesel engine rebuilt ? everyone I have talked to says there are no parts available for this 2 cylinder motor, any help or if know of a shop near northern Ohio would be appreciated.Thanks

Thanks, since I already have the engine removed, I am just going to do a rebuild providing I can find a kit, does anyone know if a kit is available? serial number 18420H

Hello, I am new to OTT, does anyone have any info on any parts for an L200 ? It has a Z1100 2 cylinder diesel in it, this was a barn find and has no compression, I removed the engine to have it rebuilt and was told by Kubota service centers that there are no parts available for this motor. I...