Recent content by Colby

Thanks Rusty. I will check it out in the morning.

Hello, I have B3200 and I am currently having issues with the speed control pedal sticking. It does not return to neutral when it is released. Besides being dangerous, it also creates problems when you try starting the engine as it has to return to neutral before tractor will start. Seems...

My trailer has side rails, about 1 foot high going around the trailer. Anything wider than 75 inches would not be able to sit on the deck.

Thanks. I have looked at the LP Seed Bed Roller. The specs indicate it is 77" wide. My 6 foot trailer is actually about 75" width on inside. The LP is a little too wide. In general, that is is what I seem to be running into. Be nice if they made a 5' model. You would think there would be...

Hi folks, I could use some feedback. I have a b3200 with FEL. I haul tractor and implements on my 6' wide trailer. I am needing a 5' 3 pt hitch type cultipacker to prepare seed beds for food plots. 5' so it will cover my tire tracks, and still narrow enough to get on my trailer. These...

Well, the Dealer could not duplicate the loud noise, or failure of the 3 pt hitch to lift. I have work to do so I am picking up the Tractor anyway. I will be prepared to video the next time. Dealer said they checked with Kubota and this apprarently is not a common issue they have had.

Good idea on going to the dealership to duplicate the screaching noise. I will do that if needed. I didn't notice any different pitch, but honestly, as soon as it makes the noise I back off the lever so I only get 1-2 seconds to listen. It doesn't sound like it can be a good thing so I back...

Hi gurn and thanks for the reply. Yes, the Hyd oil level appears good. As for the condition, the oil appears clean on the dipstick, but I have not drained any of the oil to inspect. I should have mentioned the b3200 is brand new and just now hitting the 20 hour mark. I have not found any...

I use a 20' utility trailer 7000lbs. Just big enough to handle my B3200 with 60" LP rotary cutter.

Just purchased B3200. I have put 20 hours on it so far. While using rotor tiller for about 30 minutes the 3 pt hitch would no longer lift and was making a loud screaching noise. I parked it for about 15 minutes and then tried again. The noise went away and hitch began working. After another...