Recent content by Chesapeake

Good to hear. Mine also needs assistance to lower the arms when there is no weight. I kind of expect that to go away after the o-ring takes a set and has some wear. It’s no issue to push them down though.

Can’t really be sure on the pin out or the connection of the relay, but suspect this one is similar/same. The part used for Kubota and JD looks like nippondenso 056700-6690. Hard to find specs but looks like a 12v, 20amp relay. You should be able to find a suitable version from another...

The cover/cap o-ring looks to be 04810-50550. You’ll also want the little O-ring for the valve port 04811-00100.

I buy and put Donaldson filters in my Kubota, and other stuff on purpose. Also tend to use Baldwin filters a fair bit. Every Kubota filter I've bought said "Made in Indonesia" on the label. Wouldn't surprise me to see "Made in China" though. Japan outsources just like the US.

My b6100 had that issue of the 3pt slowly lowering. Oil leaking past the piston o-ring. Old set up was an O-ring. Mine was very worn. New setup was a thin spiral ring of white PTFE or UHMW and then the O-ring. Not sure if the plastic ring is a whisper, or just to take up space and make the...

Thinking you’d want something like this for your press. https://www.harborfreight.com/20-ton-air-over-hydraulic-jack-95553.html

In case others find this thread. I removed the Transmission without removing the axle cases, tires, PTO shaft, ect... Just removed the 3 point to get access to the bolts inside, and then removed the exterior bolts. The Transmission came off fine, with just a little work to get the pinion bearing...

Seems to me fairly common practice for Corporate to require all dealers to service vehicles/equipment. And then for dealers to provide preferential treatment to their customers. I see it in tire shops, saw shops, car dealers, equipment dealers, ect..... If you have another dealers sticker on...

My tractor is a B6100, very similar. Both my factory ignition switch and the new switch I have in a box (66706-55120) have a very small key (square protrusion) that keys into the panel notch. The small square protrusion is at the bottom of the notch that is in the ignition switch. The ignition...

They say on the site you can pick the brand if you desire. I picked Donaldson..... for my B6100 the kit was quite a bit cheaper than Kubota brand, but it’s probably the hydro intake screen that sways the price in my case. I’ve yet to cut the oil filter apart and see how it looks inside. Listed...

May need to remove the valves to inspect. Might be cracked in exhaust port around the valve guide.

I have a new to me B6100D that has a torn up 13t gear (2nd gear?) and the corresponding 13t/17t gear (PTO 2nd gear?) in the tranny. Looks like the previous owner had an issue while operating a PTO driven implement in 2nd. Tranny has a click in both second and reverse. Much quieter in reverse, I...

Kubotabooks.com has pretty well all the manuals in pdf format. You can get the entire parts manual there.

The parts drawing shows an O-ring. 15331-96760 O RING

The bottom of my tank was sludge. I used a small hand pump designed for pumping lower unit oil ect. I’d add fluid, stir it all up with a bent wire through the pickup port, then pump it out. It took several repeats to get it cleaned out. I then filled it with fluid and exercised the loader for...