Recent content by bweeden

Did you check the FEL spool where the handle attaches? I had problems with the lockout affecting the throw of the spool intermittently

Nothing beats texas refinery grease, we have numerous excavators, dozers and loaders, pin wear is significantly reduced since we switched, compare timken load to any grease and you will see the difference.

Did you forget to hook up your power beyond? the pressure relief could be in bypass taking away flow

what is the part number of the gator blade, I can only find the ones with the 1 1/8 hole, I need the 7/8 for my BX 60inch MMM

Led's have difficulty in melting snow, i used leds on the back of my 1 ton beside the sander and you have to clean them off frequently because they dont generate enough heat, have you had this problem on the tractor?

My only problem is I went about a qtr of a mile, but like i said they werent dragging that bad, just a slight whine in high range from the HST

Just did a major service on my BX 23, about halfway through the day I accidently forgot I set the parking brake, I noticed it was having a hard time backing up in hi range so just dropped it to low range and it worked fine had to drive a little leveling out a few things and grabbing a couple...