Recent content by bakeroldfolks2

Well it's still not starting glows are new I'm starting to think that its getting fuel ,it sat for 8 years could the injectors have clogged up? How would I check them? Does anyone know where to get them rebuilt? I'm in the victor Valley area in Cali any help or answers

I haven't put the bucket on yet because it's still in the shop no room for it

What should the readings be i know no resistance is bad, guys this is my first time with a diesel please be patient lol

How do you test the glow plug?I guess I'm going to have to go back thru everything again

Well neither one of the indicators will get hot the new or old ones I used to be able to lite a smoke when it was running around 8 years ago lol

Thanks,my manual calls the indicator a controller, I have all the manuals for it including the loader. From the switch to the indicator I get 12v on the output side I get 11 with the new one or the old one, when I try to heat up the glows they only are getting 8to9 volts. I've checked the wiring...

My second post was after I changed out the glow controller just saying that it didn't change anything with it sorry for the confusion

I measured the voltage from the controller to the glows in the heat position it's 8or9 volts the voltage from the switch to the controller is 12 I've replaced the controller and it was the same as the old one

Well I finally got the little gal back together it turns over nice but I'm having a problem with the glows , has a new battery installed but when I try to heat the plugs all I get is 8to9 volts to them. I read that it is supposed to be 10 1/2 them to heat up I've replaced the glow control and it...

Thanks I thought so mine is down to bare metal with rust in the corners my cylinders are black so I guess the bucket would be too

One more question is the bucket supposed to be black or orange on this loader? It's really nasty right now lol

I've never heard of using regular oil in hydraulic systems before that's why I asked about it thanks Bruce

Well here's the loader I just got done with rebuilding the hydraulic cylinders it's a woods b206, they were so bad that if you turned them shaft down they just dropped out. I'm going to have to get new hoses these are really cracked. So I have a question my manual says too use 10/30 ms oil in...