85Hokie's latest activity
-
Sorry to hear of your FIL. Just a suggestion - - Look at www.tractorhouse.com or www.machinerypete.com to see what folks are ASKING... -
85Hokie replied to the thread How much is my Kubota worth?.AS RCW mentioned - the pre-Tier IV big tractors are almost worth their weight in GOLD! Almost! I would start at 30-32k and work my way...
-
85Hokie replied to the thread Another wheel spacer question....I highly recommend spacers - I had them on mine for 12 years (BX25d) zero problems and seen a huge difference too.
-
85Hokie replied to the thread Any issue with adding a D-ring shackle to the rear frame where a hitch would go?.I agree - Ideal place
-
85Hokie replied to the thread BX lift pump issues..I think you nailed it on the head with your last statement
-
Check your tractor serial number, if yours is included in the following list, contact your dealer and tell them you need...
-
Could have damaged mower and/or the tractor. I would check bottom of mower to see if there is obvious damage to the blades or spindles...
-
85Hokie replied to the thread BX1880 200 hour maintenance question.No - still need two - one before the lift pump and one before the injector pump. Moving it simply makes changing filter a lot easier!
-
85Hokie replied to the thread BX1880 200 hour maintenance question.30 seconds late ! RCVW got it first! :ROFLMAO:
-
85Hokie replied to the thread BX1880 200 hour maintenance question.Look through these older posts
-
85Hokie replied to the thread BX1880 200 hour maintenance question.There is no fuel/water separator. The filter you see in your picture is IDENTICAL to what you will find up under near the tank. Get a...
-
85Hokie replied to the thread BX1880 200 hour maintenance question.I would change the one coming after the tank .........since both filters are identical - the second one ( near the injection pump)...
-
85Hokie replied to the thread radiator for b1550.one suggestion cheapest I could fine btw
-
Guessing the one leaking is the curl cylinder? BX loaders only have one curl cylinder. I respect Dan's expertise. I would only do...
