Replacing the seal between the gear case and bevel gear case.
I have everything apart both sides and I have a few questions.
The rim on the bevel gear case is a bit rusty from the leaky seal. Is it safe to sand it down a bit or will I risk losing seal? Same for the bottom of the gear case where the cap goes (no seal but worried about cap leaking)
The boots on the steering arms and ball joints are shot. Are these worth replacing or is it a nightmare?
TIA
I have everything apart both sides and I have a few questions.
The rim on the bevel gear case is a bit rusty from the leaky seal. Is it safe to sand it down a bit or will I risk losing seal? Same for the bottom of the gear case where the cap goes (no seal but worried about cap leaking)
The boots on the steering arms and ball joints are shot. Are these worth replacing or is it a nightmare?
TIA
Last edited: