Search results

Has anyone installed a block heater on a LX3310 with full cab?It was 12 degrees F here this morning and mine didn't start up very readily after the glow plug light went out. Did start but took a bit of cranking. I would like to put one in if it is possible.

I know this has been discussed before but, has there been any modifications or fixes for the jumpy 3PH on the 2004 L3400 tractors? I am getting so tired of this that I am thinking of opening up the back end and trying to find some way to throttle the oil flow down. The adjustment knob only seems...

Is there a mid PTO available for the 4 wheel drive L2850? People tell me there is but I can see no place to install it. From the pics I have seen the drive shaft for the front is connected where it would be. Any pics of one installed on a 2850 4WD would be good.

I've had this problem for years, Starter will not engage ..nothing... I take the side panel off an tap the starter lightly and away it goes. Replaced starter years ago but still had the same problem. Problem is intermittent but if tractor has been sitting for several weeks it usually will not...

Has anyone relocated the fuel filter on their L2850? I have big hands and have a heck of a time replacing it and especially screwing the retainer nut back on. If so any pics of the relocation would be nice. Thanks in advance

Has there ever been a solution found for the jumpy 3PH problem on the L 3400 tractors? Mine seems to be even worse than it was. Maybe it just me.

Have an L2850DT with a little under 1500 Hours on it and it don't turn up as fast as it used to. I seldom use full throttle so don't know how long it has been like this. It turns about 2250 wide open no load and if I remember right it would turn over 2500 originally ( 540 RPM mark on Tach is...

My L2850 occasionally just does nothing when I turn the key to start it. If I take a hammer and just tap the starter gently it takes right off. I have replaced the starter and it still does it. Any Ideas?

Has anyone come up with a way of cushioning the 3PH on an L3400? I'm thinking there should some place where you could put a restrictor in the feed to the internal cylinder.

Is there a frost plug heater for the L2850 Kubota. I haven't been able to find one.

I know this is a common problem for the L3400 tractors but has Kubota made any attempt to find a fix for the jerking 3PH when lifting? That is the most annoying factor on my tractor. I have a L2850 and the lift is silk smooth on it. Seems that Kubota is following the trend to cheapen the quality...

I have a Kat's engine heater, the type with 3/4 pipe thread. I need the adapter that goes in the block. It is 32mm on the outside to fit the frost plug hole and threaded inside for the heater element and about 2 inches long. Does anyone know where I could get one? I have a lathe and if I could...

Here is my question, I now have the R4 tires and want to go to R1 ag tires. I can't figure out why the rears will be taller but the fronts will be lower than the R4's. It seems that would throw off the ratio between the front and rear. What am I missing?

Was reading the posts on clutches. We changed the clutch assembly on my L2850 last fall because it was slipping in 3 & 4 high. 1200 hours. We found the plates were fine looking but one of the 3 adjustment bolts with lock-nuts that the throwout bearing pushes against was worn down to and into the...