Search results

My B7200 seems to have a problem that I need some help identifying. "Betsy", my B7200 Kubota has a FEL and a rear blade on the 3-point hitch. The hydraulic fluid level appears at the correct level on the dipstick under the seat. Also under the seat there is a rubber plug with in groove in it...

Recently I removed and cleaned the fuel injectors on My B7200 because the engine sounded like it was missing and seemed to lack power. After replacing the fuel injectors and reassembling all the fuel lines I knew I had the bleed the lines. I watched Vic's You Tube Video on this and it seemed...

Steering left and right my front axle moves forward and back on either side sort of cat walking. I believe it is the Center Pin that is the issue. Does anyone know about replacing the center pin bushings and are they pressed in, that is, do you need a hydraulic press the get them out and back...

My 1986 B7200 HST Has been working great until suddenly it stopped moving. The forward / reverse pedal would not make it move in either direction. I have checked the linkages and they seem to be where they should be. Gaining access to the area where the speed control mechanism enters the...

Hi everyone, Haven't been on in a while cause everything has been running fine. However, I seem to be having some Hydraulic Problems with Betsy, my B7200. When I fill the Hydraulic fluid to the dip stick level and run the tractor the fluid starts to spewing out of what I believe to be a breather...

My B7200 seems to be losing hydraulic Fluid. I fill the Hydraulic Fluid to the correct according to the dip stick. Then when I run the engine a lot of fluid flows out from under the chain bracket plate behind the seat. I know that there is a breather back there but why is the hydraulic fluid...

Hi Gang, Haven't been here in awhile but need some advice now. My 1986 B7200HST with a D950 engine blow the water pump a couple of days ago. Got it into my garage and have picked up an after market water pump bought through my Kubota dealer. My question is, Do you have to remove the rad in...

The seal collar on my B7200HST 4wd in the front axle lower end is leaking like a sieve and I'm in the process of separating the front axle. The shop manual is helpful to a point but does not describe how to get at the seal collar (#14 - Pg. M.5-4)without disassembling the entire front axle gear...

Hi Vic, seems that I need some assistance, Please One of the bucket cylinders on my B1640 front loader was leaking so I have replaced the seals and am ready to reinstall the cylinder. Removing the cylinder ment disconnecting the hydraulic lines and emptying the oil from the cylinder. Now to...

Hi Everyone, One of the bucket cylinders on my B1640 front loader was leaking so I have replaced the seals and am ready to reinstall the cylinder. Removing the cylinder ment disconnecting the hydraulic lines and emptying the oil from the cylinder. Now to reinstall the cylinder I presume that the...

B7200 starting problems Solved Hi all, So I picked up a B7200HST about 6 mos. ago and have had a great time fixing her up. Her name is Betsy Bota and she's an "86" vintage with a FEL and 3PH Blade. She has always started although sometimes grudgingly. Recently I plowed the driveway and parked...

Hi everyone, Ron here and new to Orangetractor. I've had my Betsy for about 8 months and so far she has been running very well. She has had a hard life with little regular maintenance and I'm in the process of providing some TLC. I have been having problems with her regulator. First off I had to...