Recent content by cre73

I bent mine also when it hit my folded ROPS when raising my box blade all the way.

I did my fluid also at the 50hr service hoping to hopefully see some gains. Did not see any change. Same whine from the hydrostat and no changes in hydraulic performance. Not that I was having any actual issues to begin with but you can always hope. I saved and filtered my fluid and will use it...

Sorry maybe should of been more clear. I had my forks on the FEL and it was mostly the lift cylinders dropping about 6 or so inches every five minutes. A very slight drift in the curl cylinders but not bad.

The other day while working on my wood splitter I had it elevated with the FEL. About every five minutes I had to start the tractor and raise the FEL up again. Well that got annoying so I left the tractor running and the FEL continued drifting down at about the same rate. There are no obvious...

I do not have this feature on mine but I am interested in the answers if you do get more responses. Also I do not believe I would be happy with not being able to curl back further. If you tried to move that load any distance you would lose half of it. TTT

I personally did not feel the fluid but looked at the leak. A couple other people said they were fairly confident that it was hydraulic fluid

A friend brought their 5100 out to our lake lot and it is dripping pretty constantly from a plug located about dead center of the tractor approximately 16in from the back of the oil pan. This plug has some sort of stem that you can push up and down. When pushed up the drip stops. What are we...

Not to far in my opinion, I occasionally drive 1.75 miles to mow my other property. Just make sure you take it out of 4wd.

I hope it isn't an issue I have been doing it for while. Use the same one for the boat and the tractor. Not the exact same pump you have but a very similar design.

Nope, got my B2601 stuck yesterday. One minute everything was fine, next second four tires spinning. Luckily I was able to pull it out with my truck after multiple attempts. I did not have my FEL on at the time.

Yep had to buy a trailer mover. When I fabricated my current one I welded a 2" and 1 7/8" balls on it. I have been wanting a standard one with a receiver so I bought one today. 3PT is rated to about 1500 I think. Planned on putting an oak log in bucket. I called him back today and offered to go...

A friend called and asked if I could help get his camper in place with the tractor due to close quarters with trees. Camper is 34ft and approx 9K LBS. Probably pushing 800lbs tongue weight. I told him I didn't think so due to the weight. But after watching a few videos on youtube I rethinking my...

Its to late for me now, just got my 3rd function installed and my thumb going. But if you don't mind which one did you get and what was the price. The little searching I did for prices they were all over the place. From $900-$2000.

Ok I finished my install of my LandPride third function kit 380-149A. Needless to say the instructions suck. I am wanting to confirm that I completely remove the tube going from the power beyond port and the connection below the seat and then run my lines to these points. It looks like the...

Ok I am starting my install of my LandPride third function kit 380-149A. Needless to say the instructions suck. I am wanting to confirm that I completely remove the tube going from the power beyond port and the connection below the seat and then run my lines to these points. It looks like the...