Tiller identification on B7100

[Christianbenzon1]

Anyone able to identify?

model number plate is not readable

I need to order some parts for it

tiller is 34” wide

 

[Big Kahuna]

I can, a K-320. vintage 1977

 

[Christianbenzon1]

I can, a K-320. vintage 1977 View attachment 55333

Awesome!
Thanks a ton.
now for some searching for tines.

This forum is one of the most helpful I’ve been a part of

 

[Christianbenzon1]

I can, a K-320. vintage 1977 View attachment 55333

Any idea on a parts manual?

 

[Russell King]

Any idea on a parts manual?

Try Kubota.com illustrated parts and then search the model of the tiller.

 

[Big Kahuna]

You're not going to find information on the Kubota site. I'll try and remember who made it for Kubota.
Send me a picture of the tine.

 

[Christianbenzon1]

You're not going to find information on the Kubota site. I'll try and remember who made it for Kubota.
Send me a picture of the tine.

Correct, nothing on Kubota site.

10.5” long overall
1 5/8” width
4.5” center to center bolt holes

 

[Big Kahuna]

They really don't look bad.

 

[Big Kahuna]

70030-00322 Right 70030-00321 Left These numbers are for a K-422
I have a K-420, no listing for it anymore. It was made by Woods Brothers, your tines are very close to mine.
If want to pursue it but at $40 a tine it adds up. I would use what you have, they will till.

 

[PoTreeBoy]

If you're just looking for tines,
Www.agristoreusa.com has some with dimensions that might fit. About $10. I'm sure there are others.

 

[kubotasam]

Tiller-blades.com has many blades with dimensions that you can match. I had an old Kubota tiller and found blades that were close to replace missing ones.

 

[Christianbenzon1]

Thanks for the help, I’ll run these tines for now and now know where to find replacements.

Replacing a bearing and greasing everything up so it’s ready for Spring.

 

[Big Kahuna]

Your tines look like mine and it tills great.
Glad to help you, it's nice to see the old stuff still working.

 

[Mharvey]

Sorry to open this up again I was just wondering if you found the bearings. I’m having trouble finding them

 

[Donystoy]

Bearings are seldom a problem sourcing. Just take the original to your local bearing supply such as BDI.

 

[GreensvilleJay]

Everyone needs to buy a set of digital calipers ! Dang ,less than $20 these days...
Ask Santa or the Easter Bunny for them !!!!
set it to mm
measure ID, OD, WD
google the numbers and presto, bearing ID number will appear.

The outer seal usually will have the number stamped on it (IE: 6203-RS )