What is "splitting" a tractor?
- Thread starter leonard65
- Start date
it's the operation you have to do to replace the clutch.
You 'split' the engine from the transmission....
You 'split' the engine from the transmission....
85Hokie
Moderator
Staff member
Lifetime Member
Equipment
BX-25D ,PTB. Under Armor, '90&'92-B7100HST's, '06 BX1850 FEL
never a dumb question!!
Basically a split occurs when the clutch needs to be changed. Sometimes other part need to be changed too. breaking the tractor from front to back is the split!
Basically a split occurs when the clutch needs to be changed. Sometimes other part need to be changed too. breaking the tractor from front to back is the split!
Welcome aboard!
I'm no mechanic but I split my Ford 1210. It was easy because it isn't a big tractor but the basics are the same. Removed unnecessary things that would get in the way - in my case that was hood, fuel tank and battery. Then remove or disconnect anything that crossed the joint of the engine block/bell housing. Several wires and hydraulic lines. Support both halves of the tractor. I used a cable come-a-long from an overhead attachment point for the front and made a "kickstand" for the back half. Then removed the bell housing bolts and wiggle/pry it apart.
I'm no mechanic but I split my Ford 1210. It was easy because it isn't a big tractor but the basics are the same. Removed unnecessary things that would get in the way - in my case that was hood, fuel tank and battery. Then remove or disconnect anything that crossed the joint of the engine block/bell housing. Several wires and hydraulic lines. Support both halves of the tractor. I used a cable come-a-long from an overhead attachment point for the front and made a "kickstand" for the back half. Then removed the bell housing bolts and wiggle/pry it apart.
