Pto on front d722e??????

[jshort]

I have a d722e with splined crack shaft I'm wanting to put a double pulley on it to power a pto electric clutch under it my single groove pulley on it is not tapped to bolt another to it any ideas

 

[GreensvilleJay]

remove your pulley, and weld a 2nd pulley onto it ?

 

[North Idaho Wolfman]

Coupling and shaft off the front of the crank pulley to a carrier bearing holding the electric clutch.

 

[jshort]

Coupling and shaft off the front of the crank pulley to a carrier bearing holding the electric clutch.

I need to line it up with electrick clutch under it afraid of getting outa balance just welding another pulley

 

[GreensvilleJay]

ok... remove crankshaft pulley and have a 'machine shop' weld on the 2nd pulley.
they could use a stub 'shaft' to center the 2 pulleys,then a few tack welds to secure them
I've done 'triples' this way )
or
they could just drill 4 holes through the pair and secure with nuts,bolts and spacers. this allows you to go back to 'stock' if required.

 

[North Idaho Wolfman]

Post a picture of the crank pulley as there are many different styles.

 

[jshort]

Post a picture of the crank pulley as there are many different styles.

Will do get one rommaro

Post a picture of the crank pulley as there are many different styles.

W also the pulley is weighted that's on it

 

[North Idaho Wolfman]

Yea that style of pulley is not very easy to adapt anything to it.