overrun clutch

[jeffrockhall]

I have a M7060 with a Wallenstein PTO 10 inch chipper. The Chipper rotor weighs 400 pounds, my question is should I put a overrun clutch on the PTO shaft to protect the PTO shaft brake while the rotor winds down. It seems to me that's a lot strain on that brake.

 

[GreensvilleJay]

My 'gut' says it'd be a real good upgrade. All the towable chippers have 'disconnects' and they remove drum from engine before turning the engine off. has to be a real good reason for that !!

 

[NCL4701]

I was taught with any implement that has significant inertia (rotary cutters, old style square balers with flywheels, chippers, etc.) procedure for a normal (non-emergency) PTO stop on a tractor with PTO brake and built in over run is:

• Idle the engine to lowest RPM
• Wait for the implement/PTO shaft to wind down.
• Disengage the PTO.

That minimizes the wear on the PTO brake. I suppose an external over run clutch would further reduce the load on the PTO brake.

I’m interested to hear the thoughts of others.

 

[Bee-Positive]

I'm surprised it doesn't have a built-in ORC. If you disengage the PTO does the shaft still spin? If the PTO shaft does not spin but the rotor does as it slows down it has a built-in ORC.

I didn't see anywhere on their website or in the owners manual if this unit has one or not, I would think for the money and size that it should.

 

[SDT]

I have a M7060 with a Wallenstein PTO 10 inch chipper. The Chipper rotor weighs 400 pounds, my question is should I put a overrun clutch on the PTO shaft to protect the PTO shaft brake while the rotor winds down. It seems to me that's a lot strain on that brake.

I would.

Of course you should always return engine speed to idle before disengaging PTO. Still, that's a lot of inertial energy.

Similar model Kubota tractors of 7060 vintage have a know weak PTO brake. Subsequent models have a more robust assembly.