No power

M

mitchpinto

New member

Equipment
Kubota bx2200
May 8, 2025
6
0
1
Washington state
Bx 2200 I've had this issue before. Turn the key, fuel pump clicking. Turn the key again, glow plug indicator on...wait 5 sec, then turn the key to start. Sometimes it would start, other times it would just click. At times, it would click several times before it would start. Last week, same thing, but it wouldn't crank over, (no click, starter). I replaced the starter. Now had the fuel pump come on, and nothing else as I turned the key. I replaced the voltage regulator. Now I have no power. Tested the safety switches, replaced all the fuses, and tested the fuses for power. Tested the battery, cleaned the posts, and cleaned all of the grounding, plus added extra grounding straps. Currently, I have no power, no fuel pump, no glow plug. I have noted I have power to the middle 2 fuses, and when I turn the key to start it, I lose power in the fuse box. Any suggestions?
 
North Idaho Wolfman

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
32,856
8,342
113
Sandpoint, ID
mitchpinto said:
Bx 2200 I've had this issue before. Turn the key, fuel pump clicking. Turn the key again, glow plug indicator on...wait 5 sec, then turn the key to start. Sometimes it would start, other times it would just click. At times, it would click several times before it would start. Last week, same thing, but it wouldn't crank over, (no click, starter). I replaced the starter. Now had the fuel pump come on, and nothing else as I turned the key. I replaced the voltage regulator. Now I have no power. Tested the safety switches, replaced all the fuses, and tested the fuses for power. Tested the battery, cleaned the posts, and cleaned all of the grounding, plus added extra grounding straps. Currently, I have no power, no fuel pump, no glow plug. I have noted I have power to the middle 2 fuses, and when I turn the key to start it, I lose power in the fuse box. Any suggestions?
Click to expand...
If everything was working before the voltage regulator was changed, put the old one back in it and see what you get.
 
R

Russell King

Well-known member
Lifetime Member

Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
Jun 17, 2012
5,967
1,765
113
Austin, Texas
Is there a main fuse or fusible link that you can check for power on both sides?
 
B

Bee-Positive

Active member

Equipment
BX1880, FEL, Tooth Bar, MMM, QH, Ballast Box
Nov 16, 2022
140
166
43
Amsterdam, NY
Stop chasing your tail, get a good multimeter and follow the WSM diagram(s). Check continuity and voltages in order (i.e. continuity from battery + to starter B, starter B to slow blow fuse, slow blow fuse to main switch 30, etc.). If anything this will tell you what it isn't and maybe what it is. Hopefully it's simply a bad wire or safety switch.


BX2200 Starting System.jpg
 
M

mitchpinto

New member

Equipment
Kubota bx2200
May 8, 2025
6
0
1
Washington state
Update.
mitchpinto said:
Bx 2200 I've had this issue before. Turn the key, fuel pump clicking. Turn the key again, glow plug indicator on...wait 5 sec, then turn the key to start. Sometimes it would start, other times it would just click. At times, it would click several times before it would start. Last week, same thing, but it wouldn't crank over, (no click, starter). I replaced the starter. Now had the fuel pump come on, and nothing else as I turned the key. I replaced the voltage regulator. Now I have no power. Tested the safety switches, replaced all the fuses, and tested the fuses for power. Tested the battery, cleaned the posts, and cleaned all of the grounding, plus added extra grounding straps. Currently, I have no power, no fuel pump, no glow plug. I have noted I have power to the middle 2 fuses, and when I turn the key to start it, I lose power in the fuse box. Any suggestions?
[/
Click to expand...
 
You must log in or register to reply here.

Top Bottom