Need help please! B1750hst won't move after brush hog hits object.

K

KubotaTom

New member

Equipment
B1750hst
Sep 29, 2017
2
0
1
Tabernacle nj
Hi my name is Tom. I live on the edge of the pine gardens in Nj. I was brush hogging some high weeds when I ran over a small plastic feed bin.
My b1750hst stopped right away but the engine continued to run. I have no forward.no reverse. No pto. Loader and 3pt hitch operate fine. Shift lever will engage in low or high. I removed housing that covers hydraulic filter and the shaft that is visible either does not move or barely moves no matter what the rpm of engine. Any advice on troubleshooting and repairing this would be greatly appreciated. Thanks Tom
 
T

twomany

Active member

Equipment
B7200
Jul 10, 2017
793
138
43
Vermont
could be the center was knocked out of the clutch.

There might be an access hole on the left side of the tunnel for lubrication of the clutch throw out mechanism. A rubber plug about 2 inch diameter would close the opening.

With good light, You might be able to get a view.

If that's it, the tractor needs split.

Get the Work Shop Manual for your model.
 
L

lescarpentier

Member

Equipment
B3350
Oct 12, 2016
73
0
6
Washington
twomany said:
could be the center was knocked out of the clutch.

There might be an access hole on the left side of the tunnel for lubrication of the clutch throw out mechanism. A rubber plug about 2 inch diameter would close the opening.

With good light, You might be able to get a view.

If that's it, the tractor needs split.

Get the Work Shop Manual for your model.
Click to expand...
It's a Hydro.
 
You must log in or register to reply here.

Top Bottom