Yesterday, I was doing a little clean up on my 84 B5200, which I purchased a while back, when I noticed the right rear head bolt sticking up about 3 inches and falling over at an angle. Actually it is not a bolt but a stud with nut on the end. It fell out in my hand and appears to be broken off, as there are no threads on the bottom end. I feel like this has just happended - how could I have missed something like this. The machine "still" runs great with no leaks anywhere.
I suppose my plan is to "try" to extract the stud and replace with a proper bolt. Any ideas or advice would be much appreciated.
Thanks
I suppose my plan is to "try" to extract the stud and replace with a proper bolt. Any ideas or advice would be much appreciated.
Thanks