I have a M8200 that I need to rebuild the steering box. can anyone give me any info on how to go about this? I have the steering wheel off and cowan removed for access to box. any help is greatly appreciated
M8200 steering box repair
- Thread starter Thomas1
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
That tractor does not have a steering box, it does have a steering controller, huge difference between the two.
What is you steering doing or not doing?
Most commonly the steering controller is fine, it's usually seals in the steering cylinder that fail.
And if you've never tackled a steering controller rebuild, get the WSM in order to do it, it's not a matter of just replace parts!
What is you steering doing or not doing?
Most commonly the steering controller is fine, it's usually seals in the steering cylinder that fail.
And if you've never tackled a steering controller rebuild, get the WSM in order to do it, it's not a matter of just replace parts!
the steering controller is leaking fluid from the top where the steering shaft(from steering wheel) goes into controller. I had the local Kubota dealer order the rebuild kit for me which consist of about 6 or 7 O-rings. he cautioned me to be careful not to mess up the timing. I have never rebuilt a steering controller but with some guidance I believe I can. are there special tools required?