L3200 won't start after fuel housing reeplacement

vickark

Member

Equipment
L3200, fel,backhoe,sgr 1060 grapple, boxblade, lp bush hog,post hole auger
Jun 16, 2013
31
0
6
Texas
A limb broke off the forward hose nipple off of the fuel filter housing. I replaced it this evening. I read in the manual to open the fuel bleed valve and start the engine.
Well, it won't start. There's plenty of fuel in the bowl and all lines are secure.
Any ideas?
 

Rodeo hunter

New member

Equipment
l4400hst with loader,
Apr 2, 2014
126
2
0
Indiana
You can always crank and crack injector. Do all thre it always works with a diesel. Their might be an easier fix or way to bleed it. I know for sure crank and crack injectors. Start back to front will work. It just might take a little more time. Mine were very easy to get to on my l3000dt.

1 crank engine
2 turn injector line connector 1/3 turn ( 17 mm wrench on mine. Bubbles should come out)
Repeat steps 1-2 until all cylinders have been bled. It may take two cycles but it'll get your air out
 
Last edited:

vickark

Member

Equipment
L3200, fel,backhoe,sgr 1060 grapple, boxblade, lp bush hog,post hole auger
Jun 16, 2013
31
0
6
Texas
Well, I got the 3200 fired up. I was able to bleed down by loosening the inj. lines. Runs a little rough. It ought to line out after some use.
Thanks