L3010 Lights - Power Source

[Cypull]

I'm mounting a set of 4 55 watt work lights on my L3010 ROPS. I figure I'll be drawing 18 amps. I would prefer to draw power from behind an existing fuse (I'll put a 15 amp fuse in front of each pair of lights), but I'm not sure an adequate circuit currently exists. Any suggestions on where to tap power source would be appreciated!

Note: While I consider myself a handyman, I am less than astute when it comes to electrical circuitry. So go easy on me!

 

[meanjean]

Install an in-line 15 amp fuse right off the battery.
Add a swith somewhere convenient.
Done deal!

In line fuse is only a couple bucks, as is the switch.