Upon turning the ignition switch key on, no hazard lights appear and the temperature guage does not work. Checked fuses; ok, replaced fan belt prior to this problem. Checked battery cables and grounds, all ok. Engines starts ok and headlights work. Suggestions welcome...
L2650 Electrical Problem
- Thread starter blaze
- Start date
Could be the wiring into the fuse block or the block itself. You've covered your bases pretty well. Not much else to do but start going through it with a multimeter and see where the break is.
Kubotabooks.com has the service manual for that tractor with a wiring diagram but you'll have to wait til the site is back up (should be tomorrow).
Kubotabooks.com has the service manual for that tractor with a wiring diagram but you'll have to wait til the site is back up (should be tomorrow).
Well, I checked out the fuse block and it is getting power. Cleaned fuses to assure contact as well as neg. battery ground. No luck. Took apart access panels to the light switch and ign. switch to test but need a clear wiring diagram. Does the instrument panel get its power through the light switch???
Hi Matt,
I've using the electrial diagram to try and find the problem with my instrument panel lights not working along with the temp. guage. Checked many circuits for power and grounds. Haven't been able to find the problem with working on it for about a week on and off. Yesterday, I checked the ground from the Easy Checker, which is the instrument panel lights. and it was secure. It really seems to me to be a power problem because the temp. guage doesn't work either that points to the Combination Switch being partially faulty.
I've using the electrial diagram to try and find the problem with my instrument panel lights not working along with the temp. guage. Checked many circuits for power and grounds. Haven't been able to find the problem with working on it for about a week on and off. Yesterday, I checked the ground from the Easy Checker, which is the instrument panel lights. and it was secure. It really seems to me to be a power problem because the temp. guage doesn't work either that points to the Combination Switch being partially faulty.