L2501 and QH15

[Forvols]

I have an L2501HST with a Landpride QH15. My question is do you use spacers on the lower pins of the 3pt implement? I have a LP RCR1260 and LP BOXBLADE both cat 1 implements. I didn't use the spacers or carter pins when I had the cutter hooked up. But thought I would ask the question.

 

[Ryansweatt2004]

Yes you need to buy the bushings for all your 3pt implements. One word of caution, make sure you don’t take out your tail lights on your fenders with the quick hitch. If you have your top link too short or in the bottom pin location on the tractor side, the quick hitch will lift all the way up and into the fenders. They will bust out your tail lights on these small L01 series kubotas if your not careful. I’ve done it on my L3901 already.