Looking for lower link arms about 26" in length that would fit a Kubota L35. Also looking for the fixed drawbar.
ISO Lower Link arms for L-series tractor
- Thread starter H20man53
- Start date
fried1765
Well-known member
Equipment
Kubota L48 TLB, Ford 1920 FEL, Ford 8N, SCAG Liberty Z, Gravely Pro.
The parts you are looking for (for L35), are going to be VERY difficult to find as used parts.
I believe that those pieces may still be available new, but are likely VERY spendy.
Currently I have lower link arms from a Ford tractor which are too long and no holes for the stabilizer chains. A pain to change implements since the sway chains use the same pins and have to be removed.
Unless you find some good used ones (or the missing stash of misplaced ones
), I think you'll do better to buy the L3961 kit from your dealer. It's around $600 now.L35 Hitch Kit 3-point
I have a L35 and I'm looking for the 3-point hitch kit. The dealer says they are about $1800 after they put one together. I've also read that a L39 3-point hitch kit will work and can get them for $500?
www.orangetractortalks.com
If you search this forum by 'L3961' and my name, you should find some pictures I posted with dimensions.
Thanks for info on L3961 3 point hitch used on the L35. Have you installed the kit on your L35 yet? I would like to know how it works out.Unless you find some good used ones (or the missing stash of misplaced ones
L35 Hitch Kit 3-point
I have a L35 and I'm looking for the 3-point hitch kit. The dealer says they are about $1800 after they put one together. I've also read that a L39 3-point hitch kit will work and can get them for $500?
If you search this forum by 'L3961' and my name, you should find some pictures I posted with dimensions.
fried1765
Well-known member
Equipment
Kubota L48 TLB, Ford 1920 FEL, Ford 8N, SCAG Liberty Z, Gravely Pro.
Coleman Equipment has the L3961 3pt. hitch kit listed on their website for $594.72...... plus shipping.
A call to Coleman would seem to be in order to be certain that is the proper 3pt. kit for your L35
No readily available info for a Kubota OEM L35 drawbar.
No, I haven't. I don't think the backhoe has ever been off.
If I can, and remember (CRS setting in), I'll see if the lower arms fit. I think I can do it without removing the hoe. May be Monday.
BTW, you should be able to save shipping if you get it on your dealer's shop order. Worth considering.
I tried my L3961 parts. The lower arms I couldn't install to the rear because of interference with the backhoe. But I put them pointing to the front - the eye is the correct size and length for the pin.
The lift rods also match the size and length of the lift arm pins. The angle of the stirrup appears to match the angle of the lower arms when lying on the floor.
I didn't measure the length again, but you can see it in my earlier post.
Can you take a pic of lower link arms with measurements from ball to ball, Have any idea what you want for them, with shipping to Southern Illinois.