Home made Snow pusher for BX2380
- Thread starter etiturcotte
- Start date
Here is one I built 3 years ago
64" wide /18 " tall / 16 " wings
On my B3030 everything was to small or to big "of the shelf" & way over my budget
Lucky for me have a very good steel fabrication shop 5 minutes from work & they supplied & bent up all the steel for under $300 tax in (1 4x8 sheet 1/8 & 1 piece 1/4 " 2x4
Week of cutting,grinding & fitting
Couple nights to square it all up tack it then weld it
Sandblasted it
Painted it Kubota Orange (& most of the inside of my shop)
Work well on that sloppy wet snow & 3 swipes @ 5am & yard cleared
Sent from my SM-A520W using Tapatalk
64" wide /18 " tall / 16 " wings
On my B3030 everything was to small or to big "of the shelf" & way over my budget
Lucky for me have a very good steel fabrication shop 5 minutes from work & they supplied & bent up all the steel for under $300 tax in (1 4x8 sheet 1/8 & 1 piece 1/4 " 2x4
Week of cutting,grinding & fitting
Couple nights to square it all up tack it then weld it
Sandblasted it
Painted it Kubota Orange (& most of the inside of my shop)
Work well on that sloppy wet snow & 3 swipes @ 5am & yard cleared
Sent from my SM-A520W using Tapatalk