Height to Power change

[britej]

I have searched and come up with little information about this. How difficult is this by yourself on a LA1154? with such tight tolerances on the pin, it looks like doing this by yourself would be pretty intensive to get the holes lined up exactly. Can you do one side at a time? or have to disconnect both fulcrum pins at the same time? thanks

 

[britej]

As it turns out. Super easy. I thought the rams needed extended to fit the lower holes (reason for concern by yourself). But the holes are actually in the same arc as the height position hole. No in or out on the loader control needed. Impressive engineering actually.