FEL arm spreading issues database

Status
Not open for further replies.

mdhughes

Active member
Lifetime Member

Equipment
L3901DT
Dec 10, 2014
950
53
28
Ste Geneveive county, MO
I have created a database and a page to enter information about FEL arm measurements. We are looking to compile data on front end loader arms to see if it is a group of serial numbers or the type of attachment on the FEL that is causing the metal to bend at the tilt ram pins. We need both measurements from FEL that are and aren't having this problem. Please go to the link below and enter your data. There is a picture on the page to show where to measure the loader arms.

http://thehugheslogcabin.net/ott.php
 
Last edited by a moderator:
Status
Not open for further replies.