Drawbar question

[frysl]

Is the drawbar that came with my L3301 a standard sized, can get one at any tractor supply item, or is it a Kubota specific item?
I'd like to pick up a second one so that I can attach a trailer hitch to one and a clevis to another without having to remove the ball.
thanks,
Steve

 

[In Utopia]

Any draw bar will work.
TSC is a good source.

 

[Russell King]

It depends on which draw bar you mean. If you mean a draw bar on the 3PH then you can get that from a local supply, just need to know the category.

If you mean the drawbar that attaches to the rear axle I think you need to get it from Kubota


Sent from my iPad using Tapatalk

 

[Blondie70]

That drawbar is one big chunk of steel..and heavy..think 1" thick. I have a new 3301 and just got thru fixing a shackle on the big hole on the end of the drawbar. Bought a big shackle (not sure on size, but only the threads on the pin would go in.....got the grinder and whittled down the body of the pin until it would fit...didn't take too much. (think this was a 1" shackle)
I have my trailer balls on my box blade so got to hook that up to move trailer around.

 

[Yooper]

Drawbar on my L3901 is 2" x 1-1/4" for reference.

 

[clay45]

https://www.tractorjoe.com/35070-29710-drawbar-1

 

[cerlawson]

A steel supply shop may have metal about the right size and likely is a heck of lot cheaper than Kubota. Nothing special about the metal, usually called mild steel.

 

[North Idaho Wolfman]

Instead of spending the money on another draw bar, get one of these and bolt it on the draw bar and then any 2" receiver will work!

 

[frysl]

That's a clever idea.