I am looking to make a DIY brush cutter for me property. I am on a very steep hill and each side of my property is wooded, so to keep the brush under control with a weed trimmer is a lot of work. I had an idea to create a brush cutter very similar to how a sickle bar mower works, so I can cut along the wood line as I drive up the hill.
What I did not know is if I would need to use a gearbox off the PTO or if I just used pulleys with bearings would work. I am not sure if it would spin to fast with out a gearbox.
any suggestions?
This would on a B7300
Thank You!
What I did not know is if I would need to use a gearbox off the PTO or if I just used pulleys with bearings would work. I am not sure if it would spin to fast with out a gearbox.
any suggestions?
This would on a B7300
Thank You!