BonnySlope
Member
Equipment
BX2380 FEL Add-A-Grapple, Titan 48" Box scraper, 60" Rake, 72" Rear Blade, Flail
Hi all joining this thread kind of late, but it just happened when I got a branch 1.5" wedged between movable section and fixed portion of front grill, I was able to back off of it. Which was bent outwards toward loader arm. It now comes into contact with loader foot linkage when rising.
I'm hoping to press out some of the twist in the 90 degree bend area. without having to apply heat. I'll need to move back in line about .62 of an inch.
If I can get this section into my 12 ton bearing press I may have some luck to get it a little closer to being in line. Who'd think 3/8th steel would bend from wood.!
I'm hoping to press out some of the twist in the 90 degree bend area. without having to apply heat. I'll need to move back in line about .62 of an inch.
If I can get this section into my 12 ton bearing press I may have some luck to get it a little closer to being in line. Who'd think 3/8th steel would bend from wood.!