B9200 hydraulic control lever

[Codi]

I started noticing that the control lever for my 3 pt. hitch seemed "loose." I thought the nut that holds the lever on needed to be tightened, but it was pretty tight. Now it has gotten to the point where the lever will just drop all at once. The hydraulics don't leak down, they follow the position of the lever. I have read about friction plates being in the hydraulic control assembly, but the diagrams I have seen don't show those in the B9200 hydraulics. I also can't find where there would be a spring that needs to be replaced. Anyone have any experience with this issue?


Sent from my iPhone using Tapatalk

 

[North Idaho Wolfman]

It has 2 spring washers to adjust tension, you might need to replace the collar if that is worn down too.
Washers (2): 67156-36890 or local hardware store
Collar: 67156-36910

 

[Codi]

It has 2 spring washers to adjust tension, you might need to replace the collar if that is worn down too.
Washers (2): 67156-36890 or local hardware store
Collar: 67156-36910

Thank you! I look into this when I get back from vacation.


Sent from my iPhone using Tapatalk