b8200 cylinder disassembly

[bandaidmd]

i wont be to where the tractor is until later in the week but i will try to get a part number for you.

mine were the lift rams not the tilt.

from what i recall the fittings were std pipe thread, i know they were not anything special.

 

[bandaidmd]

ok im pretty sure this is where i got them, its the ones they call the welded cyl. The ends are too wide so i narrowed them with a cutoff wheel and you have to extend one of your hoses because the kubota one has a long pipe instead of a long hose

http://internationalhydraulicsus.co...-10-stroke-welded-hydraulic-cylinder-270.html

this might not be the exact bore and stroke i will still try and get the number for you.

If you need more help you can email me thru my profile for a quicker reply

 

[bandaidmd]

heres some photos. there were no part numbers on the cylinders.
After looking i remembered I had to trim a little of the mounting ear on the fixed end for clearance. all the fittings are std pipe thread.
I also showed the notch i used to remove my circlip, I used a die grinder.

 

[VashonFarmer]

Bandaidmd, I had found a set that are pretty darn close from the same company. No one else had anything workable. I figured I'd do the same trimming to make them fit. They also have a slightly longer throw, but I don't think it will matter, or at worst I might need to weld in a stop.

International Hydraulics seems like a good outfit. The cylinders came but had a different sized port than I was expecting. One call and he shipped out a set of adapters for free. Prices are fine.

I think I might finally have the time to finish the repair this week. I'll post a pic and part numbers for anyone else's future reference. I'll probably go ahead and pick up a set of those lift rams that you found pretty soon too.

Thanks for the help.

 

[bandaidmd]

your very welcome, i did mention you have to extend the hoses didn't I? If not you prob figured that out by now.