I'm gonna put a loader on my B7100. I'm leaning toward using the tractors hydraulics. I need to find out where to tap for my pressure line and my return. I don't have the selector valve under the seat. Also I'm going to have to fabricate my frame mounts. Anybody have any pictures, schematics or plans for these mounts. Thanks in advance for all the help.
B7100 Loader hydraulics and mounting
- Thread starter mimmoson
- Start date
Anybody with any suggestions where to tap into for a FEL. The hydraulic block has 1 fitting for a supply possibly. I heard of cutting the line pressure line coming out of the pump, which would be in the area of the hydraulic block and plumbing a loader valve there in series, but if I doint have to cut that line I would rather go that route. Doe anyone know where would my return from my loader valve would go? Thanks for any input.
Hydro block feeds control valve for loader "power beyond" from valve feeds the TPH. Return from loader valve goes into "T" screwed into fill port behind shifter.
regularjay, Power beyond from valve feeds the TPH? I'm having a lapse here on TPH. Can't seem to figure what that is. LOL. I understand the rest. I've been doing a little research. My hydraulic block is 2 pieces. I can make a new upper piece out of a block of aluminum and drill and tap for 2 fittings and just place my valve in series, ie. the front port goes to the "in" of the valve and the "out" of the valve goes to the 2nd port. Anybody seen this. Thanks for the input. Now if I can only remember what TPH is. hmmm 
Thanks.
Thanks.