b6100 front pto shaft

[Lucky]

I know this has been talked about some before, but I'm trying to find a 18 mm 22 spline pto shaft to go on the front pto stub on my b6001 (the old one just spins as all the threads on the adapter have worn down). All I need is the female adapter piece as I will then weld it onto the current shaft I am using to run a small nonkubota pump and you'll never guess (John Deere loader). Or if anyone has another idea of how to attach a shaft to this stub, I am all ears.

See this link for more info: http://www.orangetractortalks.com/forums/showthread.php?t=786

 

[Lucky]

I'm still hoping that someone has an answer or idea.

 

[smokinhart]

Smokinhart here. I see there are references to what I was doing for a front hub on the 6100 again and I thought I'd post my solution. I used an Ecoloc compression hub and a 26 mm collar to lock it on. Had my machinist design a hub shaft to extend the shaft through to the drive hub up front. Maybe a little confusing with that run together but check out this site and head out from there.
http://www.globalspec.com/SpecSearch/PartSpecs?partId={AF3709BF-908E-483D-B3B6-0001D21E1979}&vid=96328&comp=1959&qid=19577688

Ecoloc -- RfN 7110 18 x 26

Larger Low profile unit fits into hubs with smaller outside diameter and no axial displacement.

See More Product Information: Supplier's Website PDF
Specifications
Application Internal (Thru Bore)
Design Units Metric
Internal Devices
Shaft Diameter. 18.01 mm
Hub Diameter 1.02 inch
Clamping Length 0.7090 inch
Overall Length 1.73 inch
Specifications
Maximum Torque 131 Ft-lbs
Clamping Force Locking Device Generated