All 3 attach points my pot-metal (aka plastic) headlight assembly bolts to the tractor are cracked/gone. Flopping in the wind now. I almost died when I saw these assemblies are 3-5 hundred dollars. Any ideas on a cheaper one, or ideas on how to repair the one I have?...
B2920 headlight assembly
- Thread starter Brian Morrow
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Cheaper option:
Go trade it in on a TYM, Yanmar, Mahindra, or a host of other cheap tractors.
Buy a generic knock off.
Use some plastic epoxy and hope for the best.
Or, duct tape is always a poor man's repair tool, wife said if you need to reinforce it use a paperclip.
If your unsure how to do this watch a few episodes of Macgyver!
Go trade it in on a TYM, Yanmar, Mahindra, or a host of other cheap tractors.
Buy a generic knock off.
Use some plastic epoxy and hope for the best.
Or, duct tape is always a poor man's repair tool, wife said if you need to reinforce it use a paperclip.
If your unsure how to do this watch a few episodes of Macgyver!
Runs With Scissors
Well-known member
Equipment
L2501 TLB , Grappel, Brush Hog, Box Blade, Ballast box, Forks, Tiller, PH digger
Without seeing it, it is hard to say for sure; However could you fab up some homemade brackets and attach them at "non-factory" locations?