B2601 accessory switch

[Gader69]

Have a new B2601 that I'm going to mount LED light bar on the ROPS, just lining up the parts to do it. Does anyone have a part number for a Kubota or other switch that will fit in the plastic knockout holes on the RH side of instrument panel? Seems to me that's what those two plugs would be for.
Searched Kubota's online parts catalog but couldn't find anything...

 

[REVNHI]

On my B2601 I mounted the ROPS LED light bar switch on the black plastic on the right side fender by the loader joystick. I did use one of the plastic knock outs for my Kubota horn button from an L6060. The other one I am saving for a future light bar mounted to the front grill guard that way I am not running wires under the floor pan.

You can find the square switches on most of the L series cab tractors and they fit the B2601 square holes. One thing to note is that the square plug is glued in and you will need to use an exacto knife between the edge of the plug and the plastic cowling to break the seal.

 

[dburke]

Have a new B2601 that I'm going to mount LED light bar on the ROPS, just lining up the parts to do it. Does anyone have a part number for a Kubota or other switch that will fit in the plastic knockout holes on the RH side of instrument panel? Seems to me that's what those two plugs would be for.
Searched Kubota's online parts catalog but couldn't find anything...

Check out Over The River And Through The Woods - OTRATTW.com
I have a B2650 that I used their switches in the dash. I had use a dremel and lengthen the holes.

 

[Gader69]

Thanks for the replies guys, I wound up getting lighted rocker switches from Daystar, they're the right width, just had to cut the holes a bit longer.
Looks very clean and factory, available in red, green, blue.
And yes those plugs are glued in the dash, careful taking them out!