Have a B2400HSD that starts fine but then acts like it going into limp mode and won’t run or dies when I try to run it? Does this model have a seat switch or fuel cut out solenoid? Fuel is clean and filter is new!
B2400HSD starts fine but then dies
- Thread starter Richard619
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
If it's starting and Idling, then it's not the stop solenoid.
If it's starting and when you let off the key from crank it dies then it could be the stop solenoid.
If it's Idling then when you push the HST pedal it dies then there is a problem in the HST switch, other switches, or wiring.
If it's starting and when you let off the key from crank it dies then it could be the stop solenoid.
If it's Idling then when you push the HST pedal it dies then there is a problem in the HST switch, other switches, or wiring.
