Arms are dead. Oil level is OK. Not speed control valve. Selector valve (3pt to BH) is all the way. All other hydrualics work fine.
B21 3pt problem
- Thread starter shuswapnorm
- Start date
Hello, how did it happen? From one day to another? Is there a sound when you try to lift?
Have yo a Monroematik? I had the same problem and the Monreomatik was just flowing from the pump to the tank. I disconnected the wires of the electric valves one by one and found the valve that was open to the tank. I disconnected that cable and since then no problems at all.
carl
Have yo a Monroematik? I had the same problem and the Monreomatik was just flowing from the pump to the tank. I disconnected the wires of the electric valves one by one and found the valve that was open to the tank. I disconnected that cable and since then no problems at all.
carl
I run the backhoe all summer and switch to the 3 Pt for a snow blade in the winter. No unusual sounds from the hydraulics leading up to this problem. I did have some problems with the selector valve but freed it up with WD40.
Unless someone has another suggestion, my next step is to clean/replace the hydraulic filter and change the fluid.
I don't know what a Monroematik is?
Thanks
Unless someone has another suggestion, my next step is to clean/replace the hydraulic filter and change the fluid.
I don't know what a Monroematik is?
Thanks
Is it dead up or dead down? Just making sure you know that the arm won't come down unless there is a load on it.