hello to all. I have b6100 gear tranny with b 219 loader. Can this loader work on b 7100 HST ? Need some help on this deal, guys.
B 219 loader fitment
- Thread starter Tmar04
- Start date
It will fit with a minor change, the sub-frame will need to be lengthened a few inches as the HST trans is a bit longer than the gear type.
Apart from that all else should fit fine as I understand.
Of course you could always send it up my way and I can "dispose" of it for you
Apart from that all else should fit fine as I understand.
Of course you could always send it up my way and I can "dispose" of it for you
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Go and read your first post on the subject as it's not that cut and dried!
http://www.orangetractortalks.com/forums/showthread.php?t=17041
http://www.orangetractortalks.com/forums/showthread.php?t=17041
Thanks to all. The more I read, the more confused I am. Guess I will see when I have both tractors here(30 days) side by side and check all measurements. I will post results then.
Again, thank you to all who responded.
Again, thank you to all who responded.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Amen!With a cutting torch, welder and BFH anything is possible!
I read the other thread on this and the subframe mods wouldn't be all that tricky. You'll need to extend the rear plates and (possibly) move the center mounts, which are just bolt-ons. Nice and easy.